TorchLAB L1 Triple XPG - Single Level Drop In (3.0-9.5v)

Product Information

Triple Cree XP-G LED Regulated 1100 lumen P60 Drop In

Fully regulated output between 4.8 and 9.5 volts
Below 4.8v it drops out of regulation and continues running until about 3v
93% efficient driver with 2 lithium ion cells
Integrated thermal overheating protection at 120C (248F)
Shock and vibration tolerant materials and components
Heavy duty positive contact spring
Solid brass negative contact ring
Tight fit for best thermal contact with your host
Shock proof materials, components, and design
Suitable for use in weapon mounted lights
Hard anodized black finish for superior thermal emissivity and durability
22 gauge mil-spec wire with 19 strand, silver-plated copper conductors, teflon insulated
Multiple independent LEDs for more output than single LED designs (even at the same wattage)

CAUTIONS:

Do not leave unattended while running
Loading cells backwords will damage the driver, always load the positive (+) end toward the drop in (top)
Do not run primary CR123 in these. The boost driver will drain them harder and harder until the cells overheat, and may explode.
HARDpress McClicky or Zero Rez tailcap recommended (ZR does not provide additional output vs the McClicky)
DO NOT USE A SINGLE PROTECTED 16340 WITH THESE.
This light creates excessive heat.
This light may cause eye damage
This light may burn the skin at close range.
This light may cause combustibles to ignite
This light is not a toy, keep away from children

Recommended Switches:

Surefire Z41 with SF Twisty or Zero Rez or McClicky
Moddoolar Triad with SF Twisty or Zero Rez or McClicky
Zero Rez does not increase output
McClicky's should be HARDpress with unsheltered boot (ie, Z41)

POWER SUPPLY OPTIONS:

Example setups.

Surefire 6P, C2, Z2:
      You can run 2xIMR 16340 for 20 minutes of runtime or 2xIMR 18350 for even more
      (not protected, be careful how far you discharge these cells)

Bored Surefire C3, 9P, or 6P + A19 extension:
      You can run 2 x protected 18500 for about 75 minutes of runtime
      (shuts off when depleted)

This drop-in runs well on 1, but is optimized for 2 rechargeable cells
      It will give full output until your cells are completely discharged

With a single lithium cell, It will run at approximately 75% output (800+ lumens) in this configuration. These are not regulated on 1 cell. A single AW 18650 2600mAh cell will provide an hour of runtime. You can run a single 17670 for about 35 minutes.

REVIEWS:

CPF, July 17, 2010

CPF, July 22, 2010

CPF, October 24, 2010

Hertao, June 16, 2011

MODELS:

Name       Voltage 2cell (1cell)*   Modes       Tint
Triple/60 L1c        1-2 cells    1100L (800L)    High only    Cool
Triple/60 L1n        1-2 cells    1000L (700L)        High only    Neutral

* Lumen outputs are LED rated values based on power, out the front values will be less

Universal Name Key: LEDcount / Format [space] Power Modes Tint
(not all options available on all models or formats)

LEDcount: 1 (single) or 3 (triple)
Format: 60 (drop in) or M2 (head)
Power: L (low) or H (high) or D (direct drive)
Modes: 1 (high) or 3 (high, medium, low)
Tint: C (cool) or N (neutral)