Description
TorchLAB BOSS – Crenelated Bezel Frosted Titanium
Protect your BOSS and E head with our titanium crenelated bezel. An alternating 3 3 pattern for maximum impact. Choose a complimentary or contrasting color.
Installation:
Watch this video before you proceed.
- Wrenches recommended for tight fit and removal
- Remove head from body
- Clean head of oils and dirt
- Place tools over the head (hold open slightly)
- Align tools near seam between top and bottom
- Squeezing both handles, rotate tools left/top, right/bottom
- Remove tools and hand open heatsink from bezel ring
- Clean off debris from threads
- Transfer oring/lens/oring to new bezel (if needed)
- Hand tighten heatsink and bezel ring
- Confirm optic is not turning as you go
- Place tools overhead (hold open slightly)
- Align tools nearest to seams
- Squeezing both handles, rotate tools right/top, left/bottom
- Release pressure and remove tools
- Check for fit/alignment, tighten more as needed
Options:
- 0. remove oring/lens/oring sandwich from current bezel
- 1. two new orings, move lens over change to black (no GID)
- 2. fully assembled and ready to screw on, with black (no GID)
- 3. fully assembled and ready to screw on, with GID
Finishes:
- Comes in Raw, Frosted, and Black Titanium
- Raw finish matches closest to original 7075 patina
This Item is made in the USA. | |
Engineering | Tom |
Machining | Scott |
QC/Logistics | Dan |
Reviews
There are no reviews yet.